If X4 or earlier version is installed, it cannot open the Registration Mark menu. (It also might occur when opening files created with Illustrator CC2017 or earlier in later versions.) (*5) When using the 64-bit edition of CorelDraw X 6 or later, CorelDraw X4 or earlier can not be installed on the PC. Since it does not affect your data, you can print or cut it properly. (*4) When placing Segmented Registration Marks (horizontal) in Illustrator version after CC2018, the middle mark might be displayed as figure on the right. (*3) The firmware needs to be the follwong version.
* It cannot be used on the port created by other drivers (e.g. (2) When using LAN (network) connection: "Add device settings" > "TCP / IP" (1) When using USB connection: "Add device settings" > "Graphtec USB"
* In case of using Data Link in Cutting Master 4/Graphtec Pro Studio, select and use the following two patterns depending on the connection method. * Administrator permission will be required. The Cutting Master 3 / Graphtec Studio needs to be closed before the Cutting Master 4 is started. * The Cutting Master 4 and the Cutting Master 3 / Graphtec Studio cannot be used simultaneously. Note: Please use Ver.4.00 to operate FC2250 Series. Downloading Files Ver.4.40 (Latest version)